Tuesday, December 17, 2013

Using GerbView to combine positive and negative layers into a single Gerber file.

Some PCB layout programs generates traces as a positive Gerber file, and power/ground plane as a negative Gerber file, which is supposed to be combined to create a finished Gerber file.
You can use GerbView to perform this task.
To do this you can do the following:
  1. Load the negative power/ground plane file. 
  2. On the right side of the screen you will see a list of available settings for the loaded Gerber file. In the list you will find a setting  named "invert". Enable this option to create a positive display of the layer.
Sample screenshot after adding layer and inverting this:



Then load the second layer and move it to the top of the layer list.
You should now see something like this:



Finally, save the two layers to a single Gerber file using Save As option:


Press OK and select a file name for the new Gerber file.
Final result shown is below:



GerbView® is a Software Companions product, and you will find more information about it here:

2 comments:

  1. I need to convert individual layers of PCB file from pdf format to gerber files for pcb making. (Not gerber to Pdf). Can it be done????
    If so, I can buy

    ReplyDelete
    Replies
    1. Sorry for late reply, GerbView can convert from PDF to Gerber format. Please note that the quality of the conversion depends heavily on the PDF file content.

      Delete